This pre-vulcanized Laser Rubber is supplied in rolls measuring 8 inches wide x 3 ft., 6 ft., 15 ft., or 30 ft. long. Custom lengths available, call for a quote. Orange-red color. Engraves deeply and quickly so you may be able to increase your engraving velocity when using this material. Clean burning leaving a white ash residue. Good for general stamping applications or self-inking stamps with regular stamp inks. In production it has an odor that may be offensive to some people.
Material needs to be washed with detergent and water after engraving. Confirm that your laser equipment is suitable for engraving stamp dies. Check with your laser equipment manufacturer to determine compatability of equipment and software.
The suggestions in the table below are a good starting point as you begin test engraving this material. Use your laser’s software settings for “stamp” mode or “3D effects” mode. Adjust speed and power settings as needed. Use your machine’s air assist mode while engraving. Observe the following precautions:
• Laser engraving or cutting rubber can possibly ignite the material. Never leave the laser system running unattended for any reason.
• Laser engraving or cutting rubber can produce foul odors. You may need to particulate filter or odor filter your exhaust depending on your environment, installation location and local air quality control regulations.
• Laser engraving or cutting rubber can produce abrasive dust and smoke. You will need to clean your laser more frequently to reduce wear and tear and keep the optics clear.
• When vector cutting this material be sure to use a vented cutting table. Without a cutting table the likelihood of flame increases.
• After engraving, wash the material with detergent and water. Then rinse and towel dry.